Eastwood Dimple Die Hole Flares

Create a flare in sheet metal up to 1/8" (3.175mm) thick using the Eastwood Dimple Dies.

• Includes both Male and Female Dies
• Form clean 45° flares in up to 1/8” thick steel
• Made with high-strength Chrome Moly steel
• Machined to close tolerances

Simply drill the recommended hole size in the metal that you desire to dimple, then use a press to do the work. Made from heat treated Chrome Moly steel, these dies are built to last.

Hole and Flare Size

1/2" Die - Requires 1/2" hole - Flare Width 0.7"
1" Die - Requires 1" hole - Flare Width 1.4"
1-1/2" Die - Requires 1-1/2" hole - Flare Width 2.15"
2" Die - Requires 2" hole - Flare Width 2.85"
2-1/2" Die - Requires 2-1/2" hole - Flare Width 3.5"

Metal Flaring Capacity

Mild Steel: 1/8”
Aluminum: 1/8”
Stainless Steel: 3/32”

Tools Required (not included)

• A set of sharp, high-quality metal saws in sizes corresponding to those in the Die Set.
• A 20 Ton Hydraulic Shop Press or equivalent.

Outside Diameter Specification

1/2" Die - OD: 34.8mm
1" Die - OD: 56.2mm
1-1/2" Die - OD: 75mm
2" Die - OD: 101mm
2-1/2" Die - OD: 124mm